110V Magnetic Beer Pump Food Grade Stainless Steel Head 1/2'' Thread

Description

Product Description
Specifications -- 1/2 inch Inlet & Outlet; 110V/60Hz; 10W rated power; with 19 LPM (5 GPM) max flow rate, our beer pump can lift max 3.4 m (10 ft).
Food Grade Stainless Steel -- Magnetic pump head with 1/2 inch Thread is made of Food grade 304 stainless steel, High resistance to corrosion, Not easy to get rust, Non-toxic, Environmentally friendly, Lifetime-Using brewing pump
No Leak, Good Sealing -- Pump shaft is a closed static seal, Splash proof, Greatly avoiding liquid leakage and Achieving excellent sealing, Easier to prime, Amazing liquid circulation beer pump
No Noise, Quiet Operation -- Main shaft is separated from the impeller, with damping and anti-Vibration function, Reducing the influence of motor vibration on the pump, Low power consumption, High efficiency,Run smoothly, Excellent Repeatable magnetic pump
Easy to Use --- Prime by running liquid through pump prior to turning on; The liquid travels from the bottom of the valve into the pump, and once device is powered on (plugged in to outlet), the propeller circulates liquid for maximum flow; Use to dispense beer, treat water, transfer hot water from your kettle to a mash tun, or recirculate mash wort and sparge and transfer to a brew kettle
Product description
Material Type:
Stainless Steel Head
Feature:
MAGNETIC
Fully sealed beer pump motor with connecting magnetic shaft and magnetic propeller. Magnetically coupled for enhanced operation.
SAFELY TRANSFER LIQUIDS
High temperature resistance water transfer Pump, Liquid temperature up to 120 degrees Celsius, No need to manually lift a mash tun or boiled kettle to transfer liquid, Avoid human body injury, Increase speed in a safer manner, Save time and effort, Save cost
NOTE:
*Not Self-Priming, Gravity Pumping, after energization, transfer the liquid by increasing the pressure of the liquid
*No On/Off toggle switch, Barb Ending is available
*If the pump fan runs a bit hot, install a fan on the outside of the pump to cool it down
*The Liquid temperature cannot be too high(not exceed 120 Celsius Degree) or it will stop running
*If power cut suddenly during pump operation, The power supply must be turned off and Close the outlet gate valve immediately
*Pump should be installed below all pots & tanks to ensure it has a positive suction
*Keep the pump below the level of your liquid to prime and keep the line out of the pump below the liquid until the line is primed
Specifications
Head material: stainless steel
Power: 10W Voltage: 110 V
Frequency: 50/60 Hz
Current: 100/120 mA
Max flow: 19 LPM (5 GPM)
Max head: 3.4 m (10 ft)
Fittings: 12.7 mm (1/2 inch)
Speed: 2600/3000 RPM
Max temperature: 120 ℃ (248 ℉)
Package Content:
1 x Beer Pump
About Us
powered by